The secondary cell possesses internal resistance due to which some voltage is lost in the form of potential drop across it when current is flowing. Hence, the internal resistance of the cell has to be kept to the minimum. One obvious way to lessen internal resistance is to increase the size of the plates. However, there is a limit to this because the cell will become too big to handle. Hence, in practice, it is usual to multiply the number of plate inside the cell and to join all the negative plates together and all the positives ones together as shown in below Figure.
The effect is equivalent to joining many cells in parallel. At the same time, the length of the electrolyte between the electrodes is decreased with a consequent reduction in the internal resistance. The ‘capacity’ of a cell is given by the product of current in amperes and the time in hours during which the cell can supply current until its EMF falls to 1.8 volt. It is expressed in ampere-hour (Ah).
The interlacing of plates not only decreases the internal resistance but additionally increases the capacity of the cell also. There is always one more negative plate than the positive plates i.e. there is a negative plate at both ends. This gives not only more mechanical strength but also assures that both sides of a positive plate are used.
Since in this arrangement, the plates are quite close to each other, something must be done to make sure that a positive plate does not touch the negative plate otherwise an internal short-circuit will take place. The separation between the two plates is achieved by using separators which, in the case of small cells, are made of treated cedar wood, glass, wool mat, micro porous rubber and mocroporous plastic and in the case of large stationary cells; they are in the form of glass rods.
The effect is equivalent to joining many cells in parallel. At the same time, the length of the electrolyte between the electrodes is decreased with a consequent reduction in the internal resistance. The ‘capacity’ of a cell is given by the product of current in amperes and the time in hours during which the cell can supply current until its EMF falls to 1.8 volt. It is expressed in ampere-hour (Ah).
The interlacing of plates not only decreases the internal resistance but additionally increases the capacity of the cell also. There is always one more negative plate than the positive plates i.e. there is a negative plate at both ends. This gives not only more mechanical strength but also assures that both sides of a positive plate are used.
Since in this arrangement, the plates are quite close to each other, something must be done to make sure that a positive plate does not touch the negative plate otherwise an internal short-circuit will take place. The separation between the two plates is achieved by using separators which, in the case of small cells, are made of treated cedar wood, glass, wool mat, micro porous rubber and mocroporous plastic and in the case of large stationary cells; they are in the form of glass rods.